>

>

>

Designing a Geopolymer Brick for Thermal Insulation and Sustainable Construction

Designing a Geopolymer Brick for Thermal Insulation and Sustainable Construction

Abhir Soni

https://doi.org/10.67698/pjpcr.2026.0198

Abstract

The cement industry is a major contributor to carbon dioxide (CO₂) emissions, creating a need for alternative construction materials that can incorporate waste-derived resources. Moreover, cement-based materials can also heat up under external heating, creating a need for alternative materials. This study developed a lightweight geopolymer brick using a progressive lightweighting approach that combined agricultural biowaste substitution, lightweight fillers, and hydrogen peroxide (H₂O₂)-assisted foaming. Rice husk ash (RHA) and sugarcane bagasse ash (SCBA) were incorporated as agricultural waste-derived materials, replacing approximately 40% of the reactive precursor fraction. Lightweight fillers were subsequently added, followed by H₂O₂-assisted foaming to introduce additional porosity, as reflected by the estimated apparent porosity of 20.0% for the foamed geopolymer, compared with 17.6% for the non-foamed geopolymer and 16.0% for concrete. Foamed and unfoamed geopolymer samples were compared with conventional concrete in terms of mass, density, water absorption, thermal response, and static-load stability. The foamed geopolymer exhibited a density of 696 kg/m³, compared with 1320 kg/m³ for the unfoamed geopolymer and 2120 kg/m³ for concrete. During the 120-min controlled heating experiment, the temperature rise was 0.9°C for the foamed geopolymer, compared with 5.7°C and 10.9°C for the unfoamed geopolymer and concrete, respectively. However, water absorption was higher for the foamed geopolymer (28.89%) than for the unfoamed geopolymer (13.6%) and concrete (7.87%). In the incremental static-load assessment, the foamed geopolymer failed at 25 kg, whereas the unfoamed geopolymer remained intact but showed significant cracking, while conventional concrete exhibited only minor cracking. Additionally, the higher water uptake reflects the porous structure and may support evaporative cooling under suitable conditions. Overall, H₂O₂ foaming reduced density and temperature rise while increasing water uptake, showing potential for lightweight construction elements with improved temperature control.

100%
Bind a PDF file to preview.

Princeton, New Jersey, United States
Published and Managed by The Princeton Journal of Precollegiate Scholarship Inc.
ISSN: 3143-8423
DOI: 10.67698

Copyright © Princeton Journal of Pre-Collegiate Research. All rights reserved

PJPCR is independently operated and is not affiliated with Princeton University or any of its colleges, departments or programs.

Princeton, New Jersey, United States
Published and Managed by The Princeton Journal of Precollegiate Scholarship Inc.
ISSN: 3143-8423
DOI: 10.67698

Copyright © Princeton Journal of Pre-Collegiate Research. All rights reserved

PJPCR is independently operated and is not affiliated with Princeton University or any of its colleges, departments or programs.

Princeton, New Jersey, United States
Published and Managed by The Princeton Journal of Precollegiate Scholarship Inc.
ISSN: 3143-8423
DOI: 10.67698

Copyright © Princeton Journal of Pre-Collegiate Research. All rights reserved

PJPCR is independently operated and is not affiliated with Princeton University or any of its colleges, departments or programs.